Wij gebruiken cookies om uw ervaring beter te maken. Om te voldoen aan de cookie wetgeving, vragen we uw toestemming om de cookies te plaatsen. Meer informatie.
MDLR PWR is a high precision low noise and high-powered bus board for your eurorack modular systems.
With a total of 40 headers you’ll never run out of connectivity, so all your lovely modules can be easily connected.
It’s designed for use in all kind of eurorack cases up to 6U/104HP. If you have a bigger system easily add a second MDLR PWR bus board to your set up.
Due to super easy installation (it’s only about connecting two cables) this MDLR PWR PSU solution is perfect for use in any DIY projects as well.
By using an external PSU adapter there is no risk of high voltages inside your eurorack case.
MDLR PWR is fully protected on the input as well on the output to ensure maximum security.
- Dimensions 420 x 140mm
- Height 23mm
- Weight 400g
- +12V / 2A
- -12V / 1.2A
- +5V / 1.5A
Output stability ±1% for 0-100% load
Input 18V ( 16V – 20V )
Output Connectors 40 x 16 pin IDC for flat cable
Input connectors WAGO spring terminals + 5.5 / 2.1 DC inlet
Input reverse polarity
Output short current – automatic recovery
Output over current – automatic recovery
All output protections are independent for each rail
Other Input common mode LC filter with high efficiency of canceling noise and interference from input connector
Additional input filter on each regulator for minimal output noise and interferences
Shield for reducing RF interferences from regulators
Star distribution topology on PCB
Each “beam” from star topology has 4 headers with noise canceling capacitors.
In star topology center are another noise canceling capacitors
A big ground plane on both sides of PCB
Blue LEDs indicate present and drop of output voltage
Recommended power brick for one board – Mean well GSM60A18-P1J